NORAC UC5-BC-AGCO-RMC - Manual (Page 14)

14 |
3.4. Automatic System Setup
 All boom sections will move during the Retune.
 People and equipment must be clear of sprayer boom.
 Ensure the booms have sufficient range to lift fully and are clear of any power lines.
Unfold the sprayer in a location that is relatively level and where the sensors are over bare soil or gravel.
Do not conduct the retune over standing crop, weeds or grass. Also, avoid concrete or asphalt surfaces.
Ensure the boom roll suspension system is functioning properly and smoothly. Friction on wear surfaces
can be relieved using lubricants (grease, etc) or adjustment. Properly tuned suspension systems will
optimize UC5™ performance.
For best results, the hydraulic system should be under a normal load and at a normal working
temperature.
 Start the solution pump and run the sprayer’s engine at a normal working RPM for the entire
setup.
 Cycle all boom sections up and down manually for five minutes to warm the oil.
 For trailed sprayers, ensure any hydraulic flow controls are adjusted for normal field operation.
 Changing the hydraulic flow controls after or during the system setup will affect the UC5™
performance.