Replacing components, Replacing a control module, Swapping height or roll sensor locations – NORAC UC5-BC-AGCO-RMC User Manual
Page 47
Advertising
47 |
5.7. Replacing Components
5.7.1. Replacing a height or roll sensor, input or valve module:
Performing a Retune or Automatic Setup is NOT necessary.
Turn off the power, replace the component and turn on the power. The system will recognize
that there is a new component.
5.7.2. Replacing a control module:
Performing a new Automatic Setup is required.
5.7.3. Swapping height or roll sensor locations:
The sensors need to be reconfigured (mapped) to the new locations.
Advertising