PRG S400 User Manual 3.1 - Manual (Page 20)

14 PRG SERIES 400 ® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL
Figure 1-9: Rack Components / Rear View
120 x 6 TRUNK A
MODEL 20-9680-1915 120V
TRUNK B 120 x 6
120 x 6 TRUNK A
MODEL 20-9680-1915 120V
TRUNK B 120 x 6
120 x 6 TRUNK A
MODEL 20-9680-1915 120V
TRUNK B 120 x 6
120 x 6 TRUNK A
MODEL 20-9680-1915 120V
TRUNK B 120 x 6
120 x 6 TRUNK A
MODEL 20-9680-1915 120V
TRUNK B 120 x 6
120 x 6 TRUNK A
MODEL 20-9680-1915 120V
TRUNK B 120 x 6
MAIN BREAKER MUST BE SIZED
NEUT
YØ
INPUT CONECTIONS
GND XØ
NEUT YØ
400A PER Ø
MAXIMUM
208V / 15A 120V / 15A 208V / 15A
3Ø USA & CANADA
GND
120V / 208V
50-60 Hz
XØ
BUS POWER
NEUT XØ
ZØ YØ
RACK LIGHTS
YØ ZØ
FOR BRANCH CIRCUIT USE ONLY
OFF
SYSTEM
POWER / DATA
DISTRIBUTION
MODEL 23-9680-0650
S-400
MASTER
ON
PUSH
TEST TO
POWER
FRONT REAR
ZØ
ZØ
MUST BE MADE
TO PROTECT CABLES FEEDING THIS RACK
GND
ORDER:
1) CONNECT GROUND
2) CONNECT NEUTRAL
3) CONNECT PHASES
IN THE FOLLOWING
DISCONNECT IN
REVERSE ORDER
XØ
Breaker Module (rear view) - provides Trunk Outputs A
and B for distribution of power and data to Breakout Boxes.
Input Power Connectors - 400 Amp Cam-Lok style
connectors for input of house power service.
Convenience Outlet (2) - Edison style receptacle, which
provides power for optional work lights, test equipment, etc.
Neutrik® Power Outlet (2 pair) - provides power for
control consoles and/or auxiliary signal processors.
Rear Rack Light - provides illumination
for rear side of rolling rack.
Rack Light On/Off Switches - on/off switches
for front and rear rack lights.
Pilot Light - indicates when power is applied to rack
system. Provides a Push-To-Test function.
Master On Switch - powers up entire rack system.
Master Off Switch - safely powers down entire rack system.
15A Circuit Breakers - protects convenience
outlets, Neutrik connectors and L6-20 connector.
L6-20 Power Outlet - provides 208V power for a single
fixture such as a VARI
❋LITE® VL3000™ Spot Luminaire.
Test Points - color coded test point
jacks used to check rack voltages.
Phase Indicators - neon indicators light when
power is applied to rack input connectors.
Output Power Connectors - 400 Amp Cam-Lok style
connectors used for tapping power to another rack.
EXAMPLE CONFIGURATION
S400 Rack Components May Vary