PRG S400 User Manual 3.1 - Manual (Page 55)

PRG SERIES 400 ® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL 49
SOFTWARE UPGRADES
Installing a New S400 Software Version
The S400Tools Utility should be used for all system software updates. S400Tools allows a system-wide software
update with a single button press. Unlike previous versions of S400 software, v3.0 allows software update for all
devices in a single packet (instead of updating devices one-by-one).
The S400Tools Utility application can be run on any Macintosh® or Java-enabled Windows®
computer. Note that some Windows computers may not have Java installed, so it may be
necessary to install Java run time before using with a PC. Java run-times are available at:
http://
java.com/getjava/ . (Macintosh computers should already be Java-enabled.)
Requirements:
+ Macintosh® or Java-enabled Windows® computer (Java version 1.5 or later)
+ CAT5e Ethernet Cable
To install S400 Tools Utility:
Step 1. Download or copy S400Tools application file to computer.
Step 2. Connect CAT5e Ethernet Cable from computer to Series 400 system.
Step 3. Configure network connection. The application looks for a port with an IP address in the pre-defined Series
400 subnet (10.66.x.x). Configure the IP address of the port to be used to an address in that range, such as
10.66.200.1, and the subnet mask to 255.255.0.0.
Step 4. At computer, locate S400Tools application icon. Double-click icon to launch program.
To update S400 system software:
Step 1. At System Monitor window, click Configure button.
S400Tools
Current S400
Click to open Configuration
Manager window.
software version.