PRG S400 User Manual 3.1 - Manual (Page 47)

PRG SERIES 400 ® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL 41
Menu Details
Input/Output Summary – Rack Module
This menu shows the configuration of the two DMX512 rack inputs
and the two DMX512 outputs on each of the two Trunk Breakout
Boxes. In this case, Input 1 (Ca) is Universe 1 from Source A and
Input 2 (Cb) is Universe 2 from Source B. The system source default
is Source A, indicated by
src:a in the last line.
Input/Output Summary – Front of House Module
This menu shows the configuration of the ten DMX512 rack inputs
(-x-) and the two outputs of the Front of House (FOH) Module (ETHa
and ETHb). The letter after the input universe number indicates
which of the three sources is being used for that particular universe.
The letter after "src" in the last line,
src:a , indicates that Source A is
the current system default source.
Configure Inputs – Rack Module
This menu allows configuration of the two rack inputs.
The highlighted universe (Aa) can be changed by selecting the
down arrow (

) or up arrow (

). Move to the next universe by
selecting next . Pressing done will prompt a confirmation screen
that allows for changes to be committed or discarded. Note that if
no changes were made, or the menu was changed but all items
were returned to their initial value, pressing
done will result in a
simple exit to the I/O SUMMARY menu.
Configure Inputs – Front of House
This menu allows configuration of the ten Front of House (FOH)
Module inputs.
The highlighted universe can be changed by selecting the down
arrow (

) or up arrow (

). Move to the next universe by selecting
next . Pressing done will prompt a confirmation screen that allows
for changes to be committed or discarded. Note that if no changes
were made, or the menu was changed but all items were returned
to their initial value, pressing
done will result in a simple exit to the
I/O SUMMARY menu.