Proheat M80 - Manual (Page 14)

SYSTEM INPUTS
SWITCH 10 – 30V
Standard Run Mode
Preheat Run Mode
Supplemental Run Mode
COOLANT PUMP 10 – 30V
AUXILIARY Allows independent operation of Coolant Pump through
the Proheat Control Module
POWER 12 Volt or 24 Volt
M50 12V M50 24V M80 12V M80 24V
RATING BTU/hr (kW) 50,000 (15) 50,000 (15) 80,000 (23) 80,000 (23)
SYSTEM VOLTAGE
Nominal DC Voltage (Range) 12 (10 – 15) 24 (20 – 30) 12 (10 – 15) 24 (20 – 30)
CURRENT DRAW (MAX) Amps 9.5 5.2 8.5 5.2
FUEL CONSUMPTION US gal/hr (L/hr) 0.48 (1.8) 0.48 (1.8) 0.78 (2.95) 0.78 (2.95)
IGNITION TYPE Electronic Spark Ignition
COOLANT OUTPUT TEMPERATURE MAX. 185°F (85°C)
AMBIENT OPERATING TEMPERATURE -40°F to +122°F (-40°C to +50°C)
WEIGHT lbs (kg) 53 (24)
HEAT EXCHANGER CAPACITY US gal (l) 0.5 (2)
COOLANT SYSTEM
Minimum Capacity US gal (l) 2.64 (10) 2.64 (10) 2.64 (10) 2.64 (10)
Recommended Flow Rate Through
Heater US gpm (lpm) 5 (19) 5 (19) 7 (26.5) 7 (26.5)
PROHEAT G-I PCM SERVICE MANUAL 1-1
TECHNICAL
SPECIFICATIONS 1.0
SYSTEM OUTPUTS
AUXILIARY OUTPUT Same as System Voltage
Maximum 1 Amp draw (over-load shut-off protection)
High-side switched
SWITCH/TIMER Same as System Voltage
POWER Maximum 1 Amp draw (over-load shut-off protection)
High-side switched
COOLANT PUMP Same as System Voltage
Maximum 10 Amp draw (over-load shut-off protection)
High-side switched
INDICATOR LIGHT Same as System Voltage
Maximum 1 Amp draw (over-load shut-off protection)
High-side switched
DANGER
Do not use gasoline.
FUEL TYPES
COMPATIBLE Diesel (ULSD, #1, #2, Arctic), JP8, Jet A1
Bio Fuels - Contact Proheat www.proheat.com