StarTech.com SV1108IPPWEU User Manual
Page 157
Instruction Manual
150
extension cord ampere rating. Make sure that the total of all products plugged into
the wall outlet does not exceed 15 amperes.
To help protect your system from sudden, transient increases and decreases in
electrical power, use a surge suppressor, line conditioner, or un-interruptible power
supply (UPS).
Position system cables and power cables carefully; Be sure that nothing rests on
any cables.
When connecting or disconnecting power to hot-pluggable power supplies, observe
the following guidelines:
Install the power supply before connecting the power cable to the power supply.
Unplug the power cable before removing the power supply.
If the system has multiple sources of power, disconnect power from the system by
unplugging all power cables from the power supplies.
Never push objects of any kind into or through cabinet slots. They may touch
dangerous voltage points or short out parts resulting in a risk of fire or electrical shock.
Do not attempt to service the device yourself. Refer all servicing to qualified
service personnel.
If the following conditions occur, unplug the device from the wall outlet and bring it
to qualified service personnel for repair. The power cord or plug has become damaged
or frayed.
Liquid has been spilled into the device.
The device has been exposed to rain or water.
The device has been dropped, or the cabinet has been damaged. The device
exhibits a distinct change in performance, indicating a need for service.
The device does not operate normally when the operating instructions
are followed.
Only adjust those controls that are covered in the operating instructions. Improper
adjustment of other controls may result in damage that will require extensive work by
a qualified technician to repair.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
Inlet power cord selection: Detachable, maximum 2.0 m long, 18 AWG, flexible cord
(125V, 10A, 3C, NEMA 5-15P). Or, 0.75mm2, 3G, flexible cord (E.g.: H05VV-F, 250V 10A).