StarTech.com SV1108IPPWEU - Manual (Page 43)

Instruction Manual
36
DNS Server
The SV1108IPEXT/POW can either have its DNS server address assigned automatically,
or a fixed address can be specified.
For automatic DNS Server address assignment, select the Obtain DNS server
address automatically, radio button.
To specify a fixed address, select the Use the following DNS server address, radio
button and fill in the required information.
NOTE: Specifying at the alternate DNS Server address is optional.
Network Transfer Rate
This setting allows you to tailor the size of the data transfer stream to match network
traffic conditions by setting the rate at which the SV1108IPEXT/POW transfers data to
remote computers. The range is from 4–99999 Kilobytes per second (KBps).
Finishing Up
After making any network changes, be sure Reset on exit on the Customization page
has been enabled (there is a check in the checkbox), before logging out. This allows
network changes to take effect without having to power the SV1108IPEXT/POW off
and on.
ANMS (Advanced Network Management)
The Advanced Network Management Settings page allows you to set up login
authentication and authorization management from external sources. It is divided into
several sections, each of which is described in the sections that follow.
IP Installer
The IP Installer is an external Windows-based utility for assigning IP addresses to the
SV1108IPEXT/POW.
Click one of the radio buttons to select Enable, View Only, or Disable for the IP Installer
utility.
NOTE:
1. If you select View Only, you will be able to see the SV1108IPEXT/POW in the IP
Installer’s Device List, but you will not be able to change the IP address.
2. For security, we strongly recommend that you set this to View Only or Disable after
using it.