StarTech.com SV1108IPPWEU - Manual (Page 19)

Instruction Manual
12
Installation
To install the SV1108IPEXT/POW, refer to the installation diagrams on the following
pages (the numbers correspond to the numbers of the steps), and do the following:
1. Ground the unit using a grounding wire. (SV1108IPPOW Only)
2. Use the Console cable provided with this package to connect the SV1108IPEXT/
POW’s Console port, to the local console keyboard, monitor and mouse.
NOTE: 1. The Console cable comes with connectors for both PS/2 and USB mice and
keyboards – use the ones appropriate for your installation.
2. You can use any combination of keyboard and mouse connections. For
example, you can use a PS/2 keyboard with a USB mouse.
3. Use the KVM cable provided with this package to connect the SV1108IPEXT/POW’s
PC port, to the keyboard, video and mouse ports of the server that you are installing.
4. (Optional) If you want to use the virtual media function, use the USB 2.0 Virtual
Media Cable provided with this package to connect a USB port on the server to the
SV1108IPEXT/POW’s Virtual Media port.
5. (Optional) If you want to connect a serial console device or modem, plug its cable
into the RS-232 port.
6. Plug the LAN or WAN cable into the SV1108IPEXT/POW’s LAN port.
7. (SV1108IPPOW only) Use the outlet power cord provided with the package to
connect the SV1108IPPOW’s Power Outlet to the attached server for
power management.
8. (SV1108IPPOW only) Use the power cord from the server to connect the
SV1108IPPOW’s Power Inlet to an AC power source.
9. Plug the power adapter cable into the SV1108IPEXT/POW’s power jack, then
plug the power adapter into an AC power source. This completes the hardware
installation, and you are ready to start up.
NOTE: When starting up, be sure to first power on the SV1108IPEXT/POW, then power
on the connected server.