Toa FS-7000 SERIES Manual User Manual
Page 22
22
Step 3. Activate emergency evacuation announcements.
Press the Evacuation announcement button.
The Evacuation announcement indicator will illuminate and the evacuation announcement will be sent
to all selected areas.
To stop the evacuation announcement, press the Evacuation announcement button again.
Broadcast using the microphone on the FS-7000CP.
Make the desired announcement while pressing the Talk switch of the microphone.
Announcements made using the microphone will override any pre-recorded voice alarm broadcasts
being made via the FS-7000EV. These pre-recorded message broadcasts will resume once the
microphone announcement has finished.
Step 4. Once the fire has been extinguished, press the Emergency reset button on the FS-7000EV to
terminate emergency broadcasts.
The Fire indicator and Evacuation announcement indicator will extinguish, and original general-
purpose broadcasts will resume automatically.
Note
Priority broadcasts from the CP-7000CP and 1-channel BGM broadcasts will not resume
automatically.
[Pre-recorded voice alarm messages set at the factory are as follows]
Evacuation announcement:
"There is a fire. Please evacuate as quickly as possible."
False alarm announcement:
"Attention please. A few minutes ago we announced there may be a fire. However, there is no fire.
Once again, there is no fire."
Using the microphone
Using pre-recorded voice alarm messages stored in the FS-7000EV