Toa M-9000M2 CE-AU - Manual (Page 22)

22
6.2.1. Input EQ settings
The channel name to be set is displayed on the Setting Channel display.
Step 1. Select the point selection combo box (1 - 12) to switch filter points. Any point may be used.
Step 2. Select the type of filter (Through, PEQ, LPF, HPF) with the Filter Type combo box.
Step 3. Select parameters for "Freq," "Gain" and "Q."
Step 4. Check the Filter Enable checkbox to enable the filter. If enabled, it is shown on the graph.
Step 5. Repeat Steps 1 - 4 until the desired point has been reached.
ALL-Bypass Function
Clicking the "ALL-Bypass" button on the screen unchecks all Filter Enable
checkboxes and disables all filters. Selected parameters are kept.
Adjustment Function
If the "ADJUST" button on the screen is clicked, the current parameters of the 9000M2 amplifier connected by
way of the RS-232C cable are switched to the value set on the screen, allowing the set sound to be aurally
monitored.
Setting Input Channel display
ALL-Bypass button
Point selection
Filter Type selection
Parameter settings
Filter Enable checkbox
Adjust button