Toa M-9000M2 CE-AU - Manual (Page 53)

53
[When using the function button as a cross point switch:]
Select "CHANGE CROSS POINT"" from the "FUNCTION SELECT" pull-down menu, as shown below, then
click the Detail setting button at the "ASSIGNED VALUE" column to display the cross point setting dialog.
When the "EXCLUSIVE MODE" is selected in the "SOURCE SELECTION MODE," only a single cross point
can be selected for each function button of the remote controller.
If a cross point between each different input channel and the same output channel is selected for other
buttons, these buttons function as an input channel selector.
When the "SIMULTANEOUS MODE" is selected, multiple arbitrary points can be selected.
For the in-use indicator status of the remote controller, refer to the separate instruction manual.
Check the point to be switched ON on the cross point setting dialog screen.
After setting is complete, click the "OK" button and close the screen.
The set point is displayed in character strings as shown below.
Note
If the character string is longer than the display box, not all cross point setting information can be displayed. In
such cases, the set contents can be confirmed by clicking the detail setting button to open the cross point
setting dialog screen.
Detail setting button
Set content display Detail setting button