Toa M-9000M2 CE-AU - Manual (Page 23)

23
6.2.2. Output EQ settings
The channel name to be set is displayed on the Setting Channel display.
Step 1. Select the point selection combo box (1 - 12) to switch filter points. Any point may be used.
Step 2. Selecting the speaker model in the Speaker Preset field allows optimum parameter settings.
Step 3. Select the type of filter (Through, PEQ, LPF, HPF) as required using the Filter Type combo box.
Step 4. Select parameters for "Freq," "Gain" and "Q."
Step 5. Check the Filter Enable checkbox to enable the filter. If enabled, it is shown on the graph.
Step 6. Repeat Steps 3 - 5 for each of the points to be set.
ALL-Bypass Function
Clicking the "ALL-Bypass" button on the screen unchecks all Filter Enable checkboxes and disables all filters.
But setting parameters and selected speaker preset items are kept.
Adjustment Function
If the "ADJUST" button on the screen is clicked, the current parameters of the 9000M2 amplifier connected by
way of the RS-232C cable are switched to the value set on the screen, allowing the set sound to be aurally
monitored.
Note
A maximum of 10 kinds of preset items can be set with the speaker preset box. These preset items can be
uploaded simultaneously to the 9000M2 amplifier by selecting "Upload PC to 9000
All Data" from the
Communication menu on the menu bar. Each individual preset item cannot be uploaded even when "Upload
PC to 9000
SCENE" is selected.
When using the speaker preset, be sure to execute "Upload PC to 9000 All Data."
Setting Output Channel display
ALL-Bypass button
Speaker Preset
Point selection
Filter type selection
Parameter settings
Filter Enable checkbox
Adjust button