Toa M-9000M2 CE-AU - Manual (Page 51)

51
The wizard displays the contents set in the initial setting screen.
SOURCE SELECTION MODE sets the operation mode as described below when “CHANGE CROSS POINT”
function is assigned to the function switch of the Remote Controller.
EXCLUSIVE MODE:
A single cross point can be turned ON for each output channel.
SIMULTANEOUS MODE: Multiple cross points can be arbitrarily turned ON.
The mode selected here applies to all the scene memories and remote controllers.
To change the remote controller configuration, change the setting using the pull-down menu, then click the
"NEXT" button.
When not changing the setting, click the "CANCEL" button. The wizard will close.