VACUUBRAND Exhaust waste vapour condenser Peltronic - Manual (Page 14)

page 14 of 41
Use only hoses at the inlet and outlet of the condenser
with an inner diameter at least as large as the diameter of
the condenser’s connections (to avoid overpressure, and
reduction of throughput).
Comply with all applicable and relevant safety require-
ments (regulations and guidelines). Implement the re-
quired actions and adopt suitable safety measures.
Ambient conditions
➨
Do not reach for this product if it has fallen into liquid.
There is a risk of deadly electrical shock. Unplug the
system immediately.
+
Do not use this product in an area where it can fall or
be pulled into water or other liquids.
• Adopt suitable measures in case of differences from
recommended conditions, e.g., using the equipment
outdoors, installation in higher altitudes, conductive
pollution or external condensation on the exhaust
waste vapor condenser Peltronic™.
• Do not operate this product near flames.
To the best of our knowledge the equipment is in com-
pliance with the requirements of the applicable EC-direc-
tives and harmonized standards (see ”Declaration of Con-
formity”) with regard to design, type and model. Directive
EN 61010-1 gives in detail the conditions under which the
equipment can be operated safely (see also IP degree of
protection, ”Technical data”, pg. 22).
Operating conditions
➨
The exhaust waste vapor condenser Peltronic™ is not
approved for operation in potentially explosive atmo-
NOTICE