VACUUBRAND Exhaust waste vapour condenser Peltronic - Manual (Page 17)

page 17 of 41
elastomers). Use appropriate protective clothing and
safety goggles.
+
Interruption of the equipment (e.g., due to power fail-
ure), failure of connected components or of parts of
the supply, or change in parameters must not be al-
lowed to lead to dangerous conditions. In case of a
leak in the manifold, processed substances might be
released into the environment.
Comply with all notes regarding proper use of the equip-
ment, as well as operation and maintenance guidance.
+
The residual leak rate of the equipment might render
possible an exchange of gas, albeit extremely slight,
between the environment and the system.
Adopt suitable measures to prevent contamination of
the processed substances or the environment.
• Pay attention to the safety symbol ”hot surfaces” on
the equipment. Hot parts may cause burns if touched.
Adopt suitable measures to prevent any danger aris-
ing from hot surfaces. Ensure that hot surfaces of the
condenser do not cause burns. Provide a suitable con-
tact guard if necessary.
Prevent the backpressure of gases and the backflow of
condensates.
Check the liquid level in the catchpot during operation.
Check the liquid level regularly. Do not allow the catchpot
to overfill. Drain catchpot in time to avoid overflow.
Provide appropriate protective measures to allow for the
possibility of failure and malfunction. The protective mea-
sures must also allow for the requirements of the respec-
tive application.
An excess temperature protection switches off the con-
denser in case of excess temperature.
NOTICE