VACUUBRAND Exhaust waste vapour condenser Peltronic - Manual (Page 27)

page 27 of 41
Use and operation
catchpot
Catchpot
➨
Assemble the catchpot at the condenser
using the joint clip.
Separation of condensate:
The round bottom flask is coated with a protective layer to prevent disin-
tegration in case of breakage.
+
Separation of condensate: Remove joint clip, remove catchpot and
drain condensate.
Important: Comply with applicable regulations when disposing sol-
vents. Reuse if possible, purify if contaminated.
Mounting the exhaust waste vapor condenser Peltronic™
at VACUUBRAND pumping units
(not for VACUUBRAND NT pumping units with compact exhaust waste
vapor condenser)
Assembling components
+
For mounting the exhaust waste vapor condenser Peltronic™ at
VACUUBRAND NT pumping units with compact exhaust waste
vapor condenser, an assembly kit (order-no. 699935) is required.
Mechanical fastening:
➨
Dismount water cooled exhaust waste va-
por condenser.
➨
Screw the exhaust waste vapor condenser
Peltronic™ together with the holding block
with two socket-head screws to the holder
at the pump support.
holding block