Casio IT-2000W - Manual (Page 292)

292
APPENDIX B: PC Card Driver
In this chapter, each PC card driver which is called by CONFIG.SYS or by AUTOEXEC.BAT is
explained. These PC card drivers and INI file are stored in the directory, C:

CARDSOFT, on the
basic drive (C: ).
SystemSoft’s CardWizard PC card solution provides OEMs with a complete software solution for
integrating PCMCIA controllers and slots into their computers. The CardWizard software suite
provides a complete “plug and play” system software solution for both DOS and Windows 3.1.
This solution consists of the following drives and utilities. Please be aware that your particular
configuration may not include all drivers and utilities.
Socket Services (SS365SL.EXE)
Socket Services provides a standard software interface to host controller chips and isolates the
socket hardware from higher level software. Socket Services includes functions such as configuring
a socket for an I/O or memory interface and controlling socket power voltages. The Socket Services
driver included depends upon the host controller chip that the system supports.
Option
/SKT:x Number of supported slots
Range: 1 to 4 (Default: 4)
Specifies the number of slots that driver supports. On machines that have a PCMCIA adaptor that
can support more slots than are present in the machines, this value should be set to the exact
number of slots present.
Card Services (CS.EXE)
The Card Services driver manages competition for system resources and manages adapter and card
resources and configuration
Option
/POLL Poll for status change
Range : 0 to 1 (Default : 0)
When set to 1, Card Services will not use a card-status-change interrupt to determine status changes
on the system. It will instead poll for status changes (inserted card has been removed, empty slot
is now occupied, etc.). This parameter should be set to 1 if the system does not have an available
IRQ to use as a card-status-change interrupt, or if it does not support a card-status-change interrupt.