Casio IT-2000W - Manual (Page 70)

70
3.14 RAM Disk Size Change
Function
This screen is used to set the RAM DISK size (capacity). The setting will become valid after the
system has rebooted.
Fig. 3.17
Operation
Setting up the RAM disk

Adjust the RAM disk size with the “8” and “2” keys.

Confirm the setup with the “ RET” key.

When the "Hit Any Key... " message is displayed, press any key other than the “Fn” key.

The IT-2000 is turned off. After making sure that it turns off, press the reset switch on the
IT-2000 again.

After the IT-2000 is turned on again, the format confirmation screen, as shown below, will be
displayed during system start-up. Then press the “1” key. This properly formats the RAM disk.
After formatting the RAM disk is usable.
RamDisk is broken.
Format? YES:1/NO:0