Compaq RAID ARRAY 3000 EK-SMCPO-UG. C01 User Manual
Page 68
3-8 RAID Array 3000 Pedestal Storage Subsystem Hardware User’s Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: RAID Array 3000 Pedestal Storage Subsystem Hardware User’s Guide Comments:
Part Number: EK-SMCPO-UG. C01 File Name: d-ch3 Maintenance.doc Last Saved On: 12/4/00 1:50 PM
CAUTION: Always use both hands when removing or inserting an SBB.
■
Never remove a drive from the pedestal before it has completely spun
down.
■
Take care not to slam the replacement SBB into the pedestal enclosure.
1.
Unlock and open the front door.
2.
Release the drive from the pedestal slot by squeezing the mounting tabs
on the SBB together, but do not remove the SBB from the pedestal.
3.
Wait 15-30 seconds for the drive to stop spinning before removing it
from the pedestal slot.
4.
Insert an identical model SBB in the slot and push it in until an audible
click is heard indicating the SBB is fully seated (SBB front panel
mounting tabs expand and engage the pedestal shelf).
5.
Observe that the SBB status LEDs are operating.
6.
Close the front door.
Figure 3-4. Replacing an SBB