Compaq RAID ARRAY 3000 EK-SMCPO-UG. C01 User Manual
Page 83
Expansion Pedestal Option 4-3
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: RAID Array 3000 Pedestal Storage Subsystem Hardware User’s Guide Comments:
Part Number: EK-SMCPO-UG. C01 File Name: e-ch4 Expansion Pedestal Option.doc Last Saved On: 12/4/00 1:49 PM
■
There is a single 68-pin, VHDC female SCSI connector on the rear
panel which interconnects the SBB expansion pedestal to the controller
pedestal.
■
The rear panel contains an alarm switch and an external fault condition
connector.
■
The expansion pedestal contains two interchangeable fan-cooled AC
power supplies for redundant power.
■
The expansion pedestal is equipped with an internal configuration
switch which selects one of the eight (0 through 7) subsystem
configurations (set to the correct configuration setting at the factory to
properly integrate the expansion pedestal to the controller pedestal).
3000-19A
EXPANSION PEDESTAL
SLOT 6
SLOT 5
SLOT 4
SLOT 3
SLOT 2
SLOT 1
SLOT 0
ID = 8
ID = 14
Figure 4-2. Expansion pedestal slot locations and ID addresses