Compaq RAID ARRAY 3000 EK-SMCPO-UG. C01 - Manual (Page 99)

Second Controller Option 5-3
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: RAID Array 3000 Pedestal Storage Subsystem Hardware User’s Guide Comments:
Part Number: EK-SMCPO-UG. C01 File Name: f-ch5 Second Controller Option.doc Last Saved On: 12/4/00 1:48 PM
Installing the Upgrade
WARNING: To prevent an electrical discharge from damaging the SIMMs,
always wear an ESD wrist or foot strap connected to a suitable ground when
handling the memory modules.
NOTE: You can upgrade your firmware using the SCSI or network connection methods.
These methods provide the fastest way to upgrade your firmware. To update your
controller’s firmware, proceed as follows.
Saving Existing Configuration
NOTE: You must save the subsystem configuration using the StorageWorks Command
Console Client (SWCC) before performing the installation procedure. Otherwise, the RAID
controller may lose your configuration.
To save your current configuration:
Select the Storage pull-down menu from the Toolbar. Click Controller, select
Configuration, and then Save (Figure 5-2).
Figure 5-2. Saving the existing configuration