Ciprico 6500 - Manual (Page 60)

21020690 B 6500 Disk Array User’s Guide
Chapter 4 Maintenance, Troubleshooting & Hardware Replacement
Page 4 - 6 Failure Detection and Troubleshoot-ing Guidelines
Failure
Indicators
When a failure occurs on the array, an audible alarm sounds, if enabled, and
the display/operation panel reports the nature of the failure condition.
Audible Alarm
To turn off the audible alarm, press any key on the display/operation panel
(except RESET). Write down any error codes that are displayed. Pressing a key
will cause the display to change to a different message.
Error/Failure Messages
The display/operation panel shows error codes and failure messages that direct
you to the source of failure. If there are no failures, the panel will read
21 /,1(
(or assigned array name)
67$786 2..
Figure 15 Display Status
As described on the following pages, you may encounter the following types
of failures:
• Built-In Self-Test (BIST) failures
• Drive test failures
• Disk drive failures
• Over-temperature failures