Ciprico 6500 - Manual (Page 81)

6500 Disk Array User’s Guide 21020690 B
Chapter 4 Maintenance, Troubleshooting & Hardware Replacement
Initiating a Rebuild Page 4 - 27
Drive Error
Code During
Rebuild
If a drive other than the drive being rebuilt encounters an error during the
rebuild operation, the error code shown below appears, with the “X” position
displaying the number of the affected drive:
If a drive being rebuilt encounters an error during the rebuild operation, the
error code shown above appears
without the “X” drive identifier displayed.
Note This type of error is most often some type of media error.
Code in this message is read as follows:
The failed drive should be replaced immediately.
If the previous message is ignored, the failed drive not replaced, and a Reset
started, a second message is displayed at the completion of the Reset. This error
message should be ignored.
Code Meaning

Hardware Error (Sense Key)

Write Fault (Additional Sense Code)

Drive Not Ready (Additional Sense Code Qualifier )
;
Number of Failed Drive (Field Replacement Unit number)
Table 8: Error Code Meanings