Aiwa CX-N4000 U - Manual (Page 30)

CD PLAYING
'IP i
i i
EDIT/
REMAIN
DISC SKIP
I
j .:ic.
LC30<
□QD ^
o 0 o c;;
. J I
A
J
□
1
-■■ ■ P -''i- ■ '■
,■ ''I''- • , I
|- Ti
I ____ 'J
DISC CHANGE I
BASIC OPERATIONS
To check the remaining time
Press the CD EDIT/REMAIN button during playback.
The amount of time remaining until all tracks finish playing is
displayed.
To restore the play time display, press it again.
When using the remote control, press the EDIT/REMAIN button.
To skip discs
Press the DISC SKIP button on the remote control to skip a disc and
press the button to play the next disc. Play begins with the
next disc and all the discs are played once including the skipped
disc.
• Discs can be skipped during play.
To play one disc only-+ □
Press one of the DISC DIRECT PLAY buttons to start play. The
selected disc is played.
Only the indicator of the selected disc number is circled in the
display as shown ®.
If you pressed one of the DISC DIRECT PLAY buttons with the
power off, play begins with the selected disc. (See page 20.)
To remove discs
Press the A OPEN/CLOSE button to open the disc compartment.
You can remove two discs. To remove the disc on the back tray,
press the DISC CHANGE button to rotate the disc tray.
If you press the ^ OPEN/CLOSE button with the power off
The power is turned on and the disc compartment opens.
NOTE
' Do not tilt the unit with discs loaded. This may dislodge the discs.
Use under these conditions may damage the discs.
■ Do not place more than one compact disc on one disc tray at the
same time.
CHANGING DISCS DURING PLAY
Up to two discs can be replaced during play. -* ID
1 Press the DISC CHANGE button to open the disc compartment.
2 Remove the discs and place other discs.
The disc placed on the left side tray will be played next.
3 Press the A OPEN/CLOSE button to close the disc compart­
ment.
All discs are played once.
A OPEN/CLOSE
30