Aiwa CX-N4000 U - Manual (Page 58)

RECORDING
3 ,
CD EDIT/REMAIN
I DOWN DPI
^ 0 0 ^ ^
■■ " I
L... ............
1 ✓ .
HiSil^W r nr
L 1 0 .
L T i m
3:0 0
,o\
I
— DISC DIRECT PLAY —
(JJQJQO
O
-10
J J
P - D ~ !
~rv_. .p-i'V.
O
r,
.
■-n_.
8
CD EDIT/REMAIN
:i 1 ’ll ^ -
iPRGMliEDTfl
58
PROGRAMMED EDIT RECORDING
This function lets you program tracks to be recorded from all of the
discs in the CD compartment, in any order. The remaining time on
each side of the tape is displayed as you program the tracks.
1 Insert the tape to be recorded on into the deck and
set the Dolby NR.
See steps 1 and 2 on page 52 “RECORDING FROM A CD”.
2 Press the CD button and load discs onto the trays.
3 Press the CD EDIT/REMAIN button twice.
EDIT lights up and PRGM flashes in the display.
Each time it is pressed, the display changes.
-Al EDIT—►PRGM EDIT-i
□
When using the remote control, press the EDIT/REMAIN but­
ton.
4 Press the <4-^ DOWN or ►► UP button to designate
the tape iength.
Enter a length from 10 to 99 minutes.
When using the remote control
Press the numeric buttons.
Example;
@ When using a 46-minute tape, press the 4 and 6 buttons.
(D When using a 60-minute tape, press the 6 and 0 buttons.
DISPLAY
® Recording time of side A
@ Tape side
A: Front side /B; Back side
5 Select a disc by pressing one of the DISC DIRECT
PLAY buttons.
6 Press the numeric buttons and +1D button to pro­
gram a track to be recorded on side A.
DISPLAY
® Remaining time of side A
@ Total number of programmed tracks
(D Programmed tracks
7 Repeat steps 5 and 6 to program the rest of the
tracks on side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
8 Press the CD EDIT/REMAIN button to select side B.
To be continued.