CLIFFORD RSIII User Manual
Page 21
18
© 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
The remote control will beep once (or vibrate). The arm icon (7)
will flash for five seconds and the armed status icon (4) will be
displayed on the LCD.
vehicle protection
Following are descriptions of the many ways this system protects
the vehicle. Included are descriptions of the types of alarm pages
and how to interpret them.
➤
D
Doooorr L
Loocckkss - The system will automatically lock the vehicle
doors when armed.
➤
F
Faaiill-ssaaffee SSttaarrtteerr K
Kiillll - The Fail-Safe Starter Kill will prevent
the vehicles starter motor from cranking.
➤
SSttaattu
uss L
LE
ED
D - The status LED blinks approximately once per
second as a visual deterrent to potential vehicle theft.
➤
W
Waarrn
n A
Aw
waayy
®
®
- Light impacts trigger the Warn Away
®
signal.
When triggered, the siren chirps and the parking lights flash
for a few seconds.
➤
T
Trriiggggeerreed
d SSeeq
qu
ueen
nccee - Heavy impacts trip a Triggered
Sequence. The sequence consists of the siren sounding
continuously and the parking lights flashing for the
programmed duration.
➤
P
Prrooggrreessssiivvee R
Reessp
poon
nssee - If a door is opened, the system will
immediately start chirping the siren and flashing the parking
lights. Three seconds later, the siren output changes to a
➜
note: The system will not passively arm if a protected entry
or sensor is active; unless forced passive arming has been
programmed on. Refer to the Programming Options section
for information about forced passive arming).