CLIFFORD RSIII - Manual (Page 32)

29 © 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
5. Once the vehicle has started, it will run for the pre-program-
med period of time (either 12, 24, or 60 minutes - see
Programming Options section of this guide) or until a shut-
down input is triggered. When using the Directed Bitwriter,
the run time can be programmed from 1-60 minutes.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn
it to the ON (not the START)
position.
2. Press the brake pedal.
To shut down the remote start and turn off the engine:
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut
down the engine if the system receives any of the following shut-
down inputs:
➤ The brake pedal is pressed.
➤ The hood is opened.
➤ The shutdown toggle switch is put into the OFF position.
➤ The pre-programmed run time (12, 24, or 60 minutes) has
elapsed.
note: If the brake pedal is pressed before the key is in the
ON position, the engine will shut down.
iim mp poorrttaan ntt!! It is unsafe to operate a vehicle’s motor in a
garage or other closed off area. Breathing the exhaust
from the vehicle is hazardous to your health. Never acti-
vate the remote start in an enclosed space.