CLIFFORD RSIII - Manual (Page 33)

30 © 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
➤ Remote control buttons and are pressed again to
start the vehicle.
The remote control will generate a Page Notification with a
unique two-tone beep (or vibrate) and the start icon (20) will
turn off when the remote start shuts down.
valet take-over
The Valet ® Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
To perform Valet ® Take-Over:
1. Before turning off the engine, simultaneously press and
release and on the remote control. A remote start
Page Notification with a unique two-tone beep (or vibra-
tion) will be generated and the LCD will display the start
icon (20) as long as the vehicle is running. Then wait three
seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Start section for a complete list of shut-down inputs.)
note: This feature will not work if the brake pedal is
being pressed or if any shut down input is active.
➜