CLIFFORD RSIII - Manual (Page 34)

31 © 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
timer mode
Timer Mode automatically starts your vehicle engine and runs it
for a pre-programmed time period, every three hours for a total
of six operation cycles. Timer Mode helps to ensure that your
engine will start in the morning after being parked outside
during a night of extremely cold temperatures.
To enter Timer Mode:
1. Start the vehicle by pressing and releasing and on
the remote control.
2. Press and release on the remote control.
3. Within two seconds, press and release and on the
remote control again.
4. The engine will shut down and the parking lights will flash
four times. The engine will then restart to confirm that
Timer Mode has been entered.
The vehicle engine may be allowed to run for its pre-programmed
time period, or it can be shut down while running during Timer
Mode operation by pressing buttons and on the remote
control again. In either case, the vehicle will restart every three
hours for a total of six operation cycles. If the system receives a
shut-down input while the engine is running in Timer Mode, the
engine will stop, but will restart, on schedule, again in three hours!
important!! This feature must only be used in open areas,
never in an enclosed area such as a garage.
➜