CLIFFORD RSIII User Manual
Page 27
24
© 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
high security disarm
This security system offers High Security Disarm. High Security
Disarm is a feature that makes it possible to silence and reset the
system while it is triggered, without disarming the system. If the
system is triggered and the siren has been sounding for longer
than six seconds, press any button on the remote control to stop
the page, then press
on the remote control to stop the trigger
and return the unit to the armed state. The system will not
disarm, but rather reset. This prevents you from disabling the
system should you wish to disarm it without visually checking the
vehicle. Pressing
after resetting the system will disarm the
system. Pressing any button to clear the remote control page and
within the first six seconds will stop the Trigger response and
disarm the system. The six second timer is there for your conve-
nience in case the system was accidentally triggered.
disarming without a transmitter (emergency override)
If your remote control transmitter is lost or damaged, you can
manually disarm your vehicle security system. To disarm the
system without a transmitter, you must have the vehicle's ignition
key and know where the Valet
®
switch is located. Be sure to check
with your installer at the time of installation for both the location
and the preset response (1-5 presses) of the Valet
®
switch.
➜
➜