CLIFFORD RSIII User Manual
Page 28
25
© 2 0 0 2 d i r e c t e d e l e c t r o n i c s , i n c .
To disarm the security system,
turn the ignition to the ON posi-
tion. Press the Valet button the
preset number of times (one to five
times) within 5 seconds. The
factory preset is one. After five
seconds, the system will disarm. If
the system does not disarm, you
may have waited too long; turn the
ignition off and on and try again.
Location of Valet Button_________________________________
Number of Presses_____________________________________
The remote control will beep twice (or vibrate). The disarm icon
(8) will flash for five seconds and the Disarmed Status Icon (6)
will be displayed on the LCD.
silent mode
To temporarily turn off the arm or disarm chirps, use Silent
Mode™. Simply press
for less than one second before
arming or disarming, and the confirmation chirp(s) will be elim-
inated for that one operation only. If you want the arm/disarm
chirps turned off permanently, your dealer can do this for you.
➜
important! The Valet
®
switch can be programmed to
respond to 1-5 presses for the disarm function. You must
check with the installer to verify the programming for
your individual unit.
DRW-35