Aiwa CSD-MD50 - Manual (Page 10)

REGISTERING STATION NAME To change a character
Press the ◄◄ or ►► button repeatedly until the character to
be changed flashes. Then enter the desired character again.
-BAND
You can register a desired name to a station which has already
been stored in memory.
The registered name appears on the display when the station is
tuned in.
1 Press theTUNER/BAND button on the main unit
or the BAND button on the remote control to
select a band.
2 Press the I I button or turn the MULTI JOG dial
to select a preset station.
3 Press the EDIT button repeatedly until NAME
EDIT ? appears.
4 Within 5 seconds, press the ENTER button.
The unit turns into character entry mode.
5 Press the MODE button repeatedly to select the
kind of character.
[:
Capital letters—► Small letters
Number/symbol ■
■^ivSilH
I I U I I I
J U.U U
6 Turn the MULTI JOG dial to select a desired
character.
T ■iRSilUU
M U M n,,
J U.U U
7 Press the button.
8 Repeat steps 5 to 7 to enter ail the required
characters (up to 12 characters).
If you leave the unit without performing any operation for one
minute in steps 5 to 7, the character entry mode will be
canceled. If this happens, repeat from step 3.
9 Press the ENTER button.
The entered station name is displayed.
To delete characters
Press the ◄◄ or ►► button repeatedly until the character to
be deleted flashes. Then press the
II button.
To insert a space between the characters
Press the ◄◄ or ►► button repeatedly until the part to be
entered as a space flashes. Then press the DISP button.
To add a character between two characters
First, insert a space between two oharacters as described above.
Then change the space to the desired character by entering it.
1 0
ENGLISH