Aiwa CSD-MD50 - Manual (Page 4)

PREPARATION
CONNECTIONS
IMPORTANT
Be sure to connect the AM antenna first, then connect the AC
cord.
CAUTION
Use only the supplied AC cord. Use of other cords may result in
the risk of fire.
To stand the AM antenna on a surface
Fix the claw to the slot.
1 Connect the supplied AM antenna to the AM
LOOP terminal.
2 Connect the unit to an AC outiet using the
suppiied AC cord.
CONCERNING THE DISPLAY WINDOW’S DEMO
DISPLAY
When the AC cord is plugged into an electrical outlet for the first
time after purchase, a demo display will appear in the display
window. When the power is turned on, the demo display will
end. When the power is turned off, the demo display will appear
again. Until the clock is set, the demo display will appear
whenever the power is turned off. (For setting the clock, see
page 6.)
• Do not disconnect the AC cord while the power is on. Otherwise,
the data concerning the contents of the MD recording may not
be registered properly.
• Do not bring the AM antenna near the AC cord since noise will
be picked up.
• Do not unwind the AM antenna wire.
ABOUT THE POWER ECONOMIZING
MODE
You can turn on or off the power economizing mode of this unit.
When the power economizing mode is turned on
Power will be turned off automatically if 10 minutes have elapsed
while no MD, CD or tape is being played and no operation is
performed. (Power will not be turned off automatically, however,
while listening to radio broadcast.) The power economizing mode
is set to off when you purchase the unit.
To turn on/off the power economizing mode
1 Press the POWER button to turn on the unit.
2 While pressing the ■ button, press the POWER
button.
3 Press the MODE button to select "ECO ON" or
"ECO OFF."
To activate the power economizing mode, select "ECO ON."
To deactivate the power economizing mode, select "ECO
OFF."
4 Within 5 seconds, press the ENTER button.
Or simply leave the unit without pressing the ENTER button
for more than 5 seconds.
4
ENGLISH