ADLINK nanoX-BT User Manual
Nanox-bt, User’s manual
Advertising
Table of contents
Document Outline
- nanoX-BT
- Revision History
- Preface
- Table of Contents
- 1. Introduction
- 2. Specifications
- 2.1. Core System
- 2.2. Expansion Busses
- 2.3. SEMA Board Controller
- 2.4. Debug Headers
- 2.5. Video
- 2.6. Audio
- 2.7. LAN
- 2.8. Multi I/O and Storage
- 2.9. Power Specifications
- 2.10. Power Consumption
- 2.11. Operating Temperatures
- 2.12. Environmental
- 2.13. Specification Compliance
- 2.14. Operating Systems
- 2.15. Functional Diagram
- 2.16. Mechanical Dimensions
- 3. Pinouts and Signal Descriptions
- 3.1. AB Pin Definitions
- 3.2. Signal Description Terminology
- 3.3. AB Signal Description
- 3.3.1. Audio Signals
- 3.3.2. LVDS/eDP
- 3.3.3. DDI0 Channel
- 3.3.4. Gigabit Ethernet
- 3.3.5. SATA
- 3.3.6. PCI Express
- 3.3.7. Express Card
- 3.3.8. LPC Bus
- 3.3.9. USB 1.1/2.0
- 3.3.10. USB 3.0 Extension
- 3.3.11. USB Root Segmentation
- 3.3.12. SPI (BIOS only)
- 3.3.13. Miscellaneous
- 3.3.14. SMBus
- 3.3.15. I2C Bus
- 3.3.16. General Purpose I/O (GPIO)
- 3.3.17. Serial Interface Signals
- 3.3.18. Power And System Management
- 3.3.19. Power and Ground
- 4. Module interfaces
- 5. Smart Embedded Management Agent (SEMA)
- 6. System Resources
- 7. BIOS Setup
- 7.1. Menu Structure
- 7.2. Main
- 7.2.1. System Information
- 7.2.2. Processor Information
- 7.2.3. VGA Firmware Version
- 7.2.4. Memory Information
- 7.2.5. SOC Information
- 7.2.6. System Management
- 7.2.6.1. System Management > Board Information
- 7.2.6.2. System Management > Temperatures and Fan Speed
- 7.2.6.3. System Management > Power Consumption
- 7.2.6.4. System Management > Runtime Statistics
- 7.2.6.5. System Management > Flags
- 7.2.6.6. System Management > Power Up
- 7.2.6.7. System Management > LVDS Backlight
- 7.2.6.8. System Management > Smart Fan
- 7.2.7. System Date and Time
- 7.3. Advanced
- 7.4. Boot
- 7.5. Security
- 7.6. Save & Exit
- 8. BIOS Checkpoints, Beep Codes
- 9. Mechanical Information
- Safety Instructions
- Getting Service