ADLINK nanoX-BT - Manual (Page 46)

Page 46 nanoX-BT
Feature Options Description
Device power-up delay Auto
Manual Maximum time the device will take before it properly reports itself to
the Host Controller. 'Auto' uses default value: for a Root port it is 100
ms, for a Hub port the delay is taken from Hub descriptor.
Mass Storage Devices Info only List current USB mass storage devices.
7.3.5.1. USB > Chipset USB Configuration
Feature Options Description
USB Configuration Info only
USB OTG Support Enabled
Disabled Enable/Disable USB OTG support.
USB VBUS On
Off VBUS Should be On in Host Mode. It should be Off in OTG
device mode..
XHCI Mode Enabled
Disabled
Auto
Smart Auto Mode of operation of xHCI controller.
USB 2.0 (EHCI) Support Enabled
Disabled Control the USB EHCI (USB 2.0) functions. One EHCI controller
must always be enabled.
USB Per Port Control Enabled
Disabled Control each of the USB ports (0~3). Enable: Enable USB per
port; Disable: Use USB port x settings.
USB Port #0~3 Enabled
Disabled Enable/Disable USB port 0-3.
7.3.6. Network
Feature Options Description
Network Info only
Network Stack Enabled
Disabled Enable/Disable UEFI network stack.
LAN Controller Enabled
Disabled Enable/Disable LAN controller.
Wake on LAN Disable
Enabled If Enabled: LAN_PWR is always on; If Disabled: LAN_PWR is off
after entering Suspend mode.
7.3.7. PCI and PCIe
Feature Options Description
PCI and PCIe Info only
PCI Common Settings Info only
PCI Latency 32 PCI Bus Clocks
64 PCI Bus Clocks
96 PCI Bus Clocks
128 PCI Bus Clocks
160 PCI Bus Clocks
192 PCI Bus Clocks
224 PCI Bus Clocks
248 PCI Bus Clocks Value to be programmed into PCI latency timer register.