ADLINK nanoX-BT - Manual (Page 44)

Page 44 nanoX-BT
7.3.2. Memory
Feature Options Description
Memory Info only
Total Memory Info only Display total memory
DIMM#0/1 Info only Display DIMM#0/1
SPD Write Protect Enabled
Disabled Enabled: Writes to SMBus slave addresses A0h – Aeh are disabled
Max TOLUD Dynamic Maximum value of TOLUD
7.3.3. Graphics
Feature Options Description
Graphics Info only
IGFX VBIOS Version Info only
Primary Display Auto
IGD
PCIE Select which graphics device (IGD/PCI) should be primary display
Integrated Graphics Device Enabled
Disabled Enabled: Enable Integrated Graphics Device (IGD) when selected
as the primary display; Disabled: Always disable IGD
Aperture Size 256MB Select the aperture size
DVMT Pre-Allocated 64M Select DVMT 5.0 Pre-Allocated (Fixed) Graphics Memory size used
by the Internal Graphics Device.
DVMT Total Gfx Mem 256MB Select DVMT5.0 Total Graphic Memory size used by the Internal
Graphics Device.
LVDS Backlight Mode BMC Mode
GTT Mode Select LVDS backlight control function.
AMI Graphics Output Protocol Policy
[UEFI GOP only] Submenu User select monitor output by graphics output protocol
GT – Power Management Control Info only
RC6 (Render Standby) Enabled
Disabled Enable/Disable render standby support
7.3.3.1. AMI Graphics Output Protocol Policy
Feature Options Description
Intel(R) Valley View Graphics Controller Info only
Intel(R) GOP Driver Info only
Output Select
[List connect device] CRT Output Interface.
Brightness Setting
[LFP device connect only] 255 Set GOP Brightness value
BIST Enable Enabled
Disabled Starts or stops the built-in self-test (BIST) on the integrated display
panel.