ADLINK nanoX-BT - Manual (Page 65)

nanoX-BT Page 65
9.2. Thermal Solution
9.2.1. Heat Spreaders
The function of the heat spreader is to ensure an identical mechanical profile for all COM Express modules. By using a heat spreader, the
thermal solution that is built on top of the module is compatible with all COM Express modules.
9.2.2. Heat Sinks
A heat sink can be used as a thermal solution for a specific COM Express module and can have a fan or be fanless, depending on the
thermal requirements.
9.2.3. Installation
Install a heat spreader or heat sink using the following instructions.
Step 1: Place the COM Express module onto the connectors on the carrier board as shown.
Then press down on the module until it is firmly seated on the carrier board.
Step 2: Remove the protective membranes from the thermal pads.