ADLINK nanoX-BT - Manual (Page 41)

nanoX-BT Page 41
Feature Options Description
V3.30 Read only Display actual V3.30 voltage
VIN Read only Display actual VIN voltage
AIN7 Read only Display actual AIN7 voltage
7.2.6.4. System Management > Runtime Statistics
Feature Options Description
Runtime Statistics Info only
Total Runtime Read only The returned value specifies the total time in minutes the system
is running in S0 state.
Current Runtime Read only The returned value specifies the time in seconds the system is
running in S0 state.
This counter is cleared when the system is removed from the
external power supply.
Power Cycles Read only The returned value specifies the number of times the external
power supply has been shut down
Boot Cycles Read only The Bootcounter is increased after a HW- or SW-Reset or after a
successful power-up.
Boot Reason Read only The boot reason is the event which causes the reboot of the
system.
7.2.6.5. System Management > Flags
Feature Options Description
Flags Info only
BMC Flags Read only
BIOS Select Read only Display the selection of current BIOS ROM
ATX/AT-Mode Read only Display ATX/AT-Mode
Exception Code Read only System exception reason
7.2.6.6. System Management > Power Up
Feature Options Description
Power Up Info only
Power Up watchdog
Attention: F12 disables the Power Up
Watchdog.
Enabled
Disabled The Power-Up Watchdog resets the system after a certain
amount of time after power-up.
ECO Mode Disabled
Enable Reduces the power consumption of the system
Power-up Mode
Attention: The Power-Up Mode only has effect,
if the module is in ATX-Mode.
Turn on
Remain off
Last State Turn On: The machine starts automatically when the power
supply is turned on.
Remain Off: To start the machine the power button has to be
pressed.
Last State: When powered on during a power failure the system
will automatically power on when power is restored.