Bonaire / Celair (Tekelek) - Manual (Page 18)

LP SERIES OWNER’S MANUAL
Controls Setup & Commissioning
TEK600 SERIES CONTROL Page 18
Parameter Settings Table
The below table is a parameter chart for setting the unit.
This chart is also printed on the back of the wall switch.
Setting Installer Parameters.
Press and hold the FAN+TIMER buttons for 10 seconds, release, and press the TIMER
button once
Parameters Dump delay Pre-cool Dump interval Pre-fill
Parameter indicator 2hr light 4hr light 8hr light 2+4hr light
OFF
• • •
ON
• •
(default)*
• •
(default)*
• •
(default)*
0HR
•
(default)*
1HR
• •
2HR
• • •
4HR
• • • •
8HR
• • • • •
12HR
• • • • • •
Parameter
setting
(Number of
AUTO light
flashes)
24HR
• • • • • • •
* Note: the default settings in the above table are factory set.