Ditch Witch JT25 - Manual (Page 180)

JT25 Operator’s Manual
Service - 179
250 Hour
CMW
250 Hour
Drilling Unit
Inspect Air Intake System
Inspect intake piping for cracked hoses, loose
clamps, or punctures. Tighten or replace parts as
necessary.
Tier 3: Change Engine Oil and Filter
Drain oil (3), change filter (4), and add 11.5 qt (10.9
L) of Tier 3 DEO at fill (2). Check oil level at dipstick
(1).
Location Task Notes
DRILLING
UNIT Inspect air intake system
Tier 3: Change engine oil, initial Only applies to units with Tier
3 engines operating with high
sulfur fuel (sulfur content >15
ppm).
NOTICE: Units are initially filled with Tier 4i
DEO engine oil. If operating with high sulfur fuel
(greater than15 ppm sulfur, found oust i de of
US, Canada, EU and Japan), change oil initially
at 250 hours.
IMPORTANT: Use oil specified in temperature
chart found in “Recommended Lubricants/
Service Key” on page 165.
j37om055h.eps j37om055h.eps
11
33
22
44
j37om033h.eps j37om033h.eps