Hatteland Display 19 inch - HM 19T14 MMD (TEMPEST) - Manual (Page 22)

22 Operation
IND100064-31
Status LED Overview
Status LED Overview
The unit features a multi purpose indicator LED status ring which through different patterns. Realtime
activity gives back the status of the signal detected, power on/off, calibration, menu activity and more.
The LEDs are multicolored which either illuminate green, red or orange, based on the activity.
OFF (No power connected)
8 LED OFF
OFF (Standby, power detected)
8 RED LED STATIC ON
ON (Signal Search)
1 GREEN LED MOVEMENT looping.
ON (Signal OK)
8 GREEN LED STATIC ON
ON (No Signal)
4 RED LED STATIC ON
ON (Menu Delay)
7 GREEN LED STATIC +
1 LED OFF MOVEMENT doing 1 loop.
OFF (Shutdown)
1 RED LED MOVES for 3 sec. After additional
3 secs, all leds turns RED.
ALARM / Buzzer*
or
4 ORANGE LED STATIC ON
Turned on when command is activated or external
12VDC is applied.
* Alarm / Buzzer notes:
1: Can operate either as visible Alarm LED, or visible Alam LED + Audible Buzzer Sound.
2: Alarm / Buzzer function can be activated through SCOM (Serial Remote Control) or via Multifunction Cable (RS-232) with applied 12VDC.
3: Please review http://www.hatteland-display.com/pdflink/inb100018-3.php (internet / own manual) and
“Pin Assignments - Multifunction Cable Outputs” chapter in this manual for more information.
ON (Calibrated)
4 GREEN LED STATIC ON
ON (Calibrated +)
4 GREEN LED STATIC ON + where 1 show
BRIGHTNESS INDICATION POSITION
ON (Calibrated -)
4 GREEN LED STATIC ON + where 1 show
BRIGHTNESS INDICATION POSITION
For ECDIS Calibrated Products
For units that are ECDIS calibrated from factory, the following LED pattern (Calibrated) indicates that the
backlight/brightness is at calibrated level. (Calibrated +) or (Calibrated -) means that the
brightness adjustment value is above or below the calibrated brightness level. Fine adjust the brightness
in terms of decreasing or increasing the value until the pattern for (Calibrated) is reached.