Hatteland Display 19 inch - HM 19T14 MMD (TEMPEST) - Manual (Page 40)

40 User Controls
OSD Menu Functions
IND100064-21
Display / Setup / Service Menu / Elapsed Time (hr)
Function only available in “Full” menu mode.
This function will show the current elapsed running time for the unit in hours. It is based on that the display
has actually shown a valid image on screen during that time and not just how long the product has been
powered on. It can be used to determine the life span in respect of what the MTBF for the display or
backlight is specified to. This information is stored electronically on the EVX component board.
Example: “452”
Display / Setup / Service Menu / Current Temp
Function only available in “Full” menu mode.
This function will show the current temperature measured by the Video Controller EVX Component board.
The value is displayed in degree Celcius. Note: Pr. revision 15 of this manual the temperature function is
not implemented and will display “na” instead (not available).
Display / Setup / Service Menu / Fault Status
Function only available in “Full” menu mode.
This function will show the last recorded fault message detected by the display controller. This information
is stored electronically on the EVX component board. Example: “Video Chip, DVI Chip, NVRAM, DDC”
Display / Source / Single / xxx
This function will indicate what physical signal inputs is considered to be detectable by the OSD Menu
and the display controller. The amount of signal inputs available will depend on the physical Multifunction
Cable you have installed in the system. You can choose what sources are to be detectable and a icon
next to each source will indicate its activity. When you for instance use the Swap Source function it will
swap between all the indicated ones. Possible sources might include: Analog RGB 1, Analog RGB 2,
Digital (DVI), S-Video 1, S-Video 2, S-Video 3, Composite 1, Composite 2 and Composite 3.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.
Display / Source / PIP / xxx
This function will indicate what physical signal inputs is considered to be detectable by the OSD Menu,
the display controller and what is visible in the window overlay (Picture-In-Picture). The amount of signal
inputs available will depend on the physical Multifunction Cable you have connected to the unit.
You can choose what sources are to be detectable and a icon next to each source will indicate its activity.
When you for instance use the Swap Source/PIP function it will swap between all the indicated ones.
Possible sources might include: Analog RGB 1, Analog RGB 2, Digital (DVI), S-Video 1, S-Video 2,
S-Video 3, Composite 1, Composite 2 and Composite 3.
Note: This function is by factory default set to auto detect the signal source automatically. It means if you
have Composite 1 and Composite 2 set as sources and you loose signal on Composite 1, the function will
automatically switch to the next signal detectable, which in this example is Composite 2. If no signals are
detectable the image will be black.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.