Hatteland Display 19 inch - HM 19T14 MMD (TEMPEST) - Manual (Page 41)

41 User Controls
OSD Menu Functions
IND100064-21
Display / Source / PBP / xxx
This function will indicate what physical signal inputs is considered to be detectable by the OSD Menu,
the display controller and what is visible in the window overlay (Picture-By-Picture). The amount of signal
inputs available will depend on the physical Multifunction Cable you have connected to the unit. In PBP
mode, both inputs will share same hardware for video signal processing. In some cases
(depending of signal quality and content) there might be minor image quality degradation in PBP mode.
You can choose what sources are to be detectable and a icon next to each source will indicate its
activity. When you for instance use the Swap Source/PBP function it will show two window overlays at the
same time next to eachother. Possible sources might include: Analog RGB 1, Analog RGB 2,
Digital (DVI), S-Video 1, S-Video 2, S-Video 3, Composite 1, Composite 2 and Composite 3.
Note: This function is by factory default set to auto detect the signal source automatically. It means if you
have Composite 1 and Composite 2 set as sources and you loose signal on Composite 1, the function will
automatically switch to the next signal detectable, which in this example is Composite 2. If no signals are
detectable the image will be black.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.
Display / Power Off
This function will turn off the unit (soft power off) and shut down the display controller and cut internal power
to all components except the power module. The LED indicator ring/power leds will all illuminate red. The
unit will enter standby mode. It does the same function as pressing the power button located on the user
controls/front bezel. Please note that the power will still be present inside the unit because of the power
cable is still physically connected to the power module.
● Press the right (►) button to activate. A confirmation requester will appear. Use +/- to confirm.