Hatteland Display 19 inch - HM 19T14 MMD (TEMPEST) - Manual (Page 24)

24 User Controls
IND100064-24
OSD Menu Overview
Please note: Factory default illustrations only! Available functions, icons and text may deviate slightly from actual OSD menu on
your product due to different OSD software configurations and customized solutions.
OSD Functions Map
The OSD menu consists of main function groups with sub menu groups. On the following pages a complete map of the available
functions is shown. The following section should be viewed in color. Please note that the red selection bar is not indicated in any of
the following illustrations.
Main Group #1
- Picture ▲
Brightness
█
Contrast
Phase
Frequency
Sharpness
Color
Tint
Video System
PIP/PBP Adjustment
Advanced Settings
Swap Source
Picture Info
Auto Setup
▼
Main Group #2
- Setup ▲
OSD Settings
█
User Settings
Load Default
Direct Access
Test Pattern
Service Menu
▼
Main Group #3
- Source ▲
Single
█
PIP
PBP
▼
Master Group
- Display ▲
Picture
█ Setup
Source
Power Off
▼
Execute Function?
+/- = Yes ◄► = No
Legend Map
The OSD menu have functions that are specific for RGB mode, DVI mode or when using the “Full”
or “Simplified” menu structure. This means that not all functions shown in the menu structure is available
in all modes. To easier identify which function is available in what mode, the illustrations in this section is
marked with different colors (legends). These colors are not visible in the real OSD menu.
= Always available for all modes.
= Always available for all modes.
= Only available in “Full” menu mode.
= Only available in RGB mode, i.e. VGA/RGB signal input is shown full screen.
= Only available in “Full” and RGB modes.
= Only available in DVI/RGB mode.
= Only available in Comp/S-VHS mode, i.e. Video Signal is shown full screen.
= Only available if Picture-In-Picture (PIP) or Picture-By-Picture (PBP) is on.
The symbols (+,-,◄►) indicate
what physical button to press on
the user control.
Main Menu - Display
In this illustration the 3 main groups are shown.
OSD Passwords / Keycodes
If a requester appear asking for a password during entering the OSD menu, please use keycode: 3 2 1
This feature is required for ECDIS Compliance and may be factory default.
A different code may also be entered to enable the Full Menu mode, please use keycode: 1 5 8
Review the menu descriptions later in this manual for complete details for both the 321 and 158 codes.