Hatteland Display 19 inch - HM 19T14 MMD (TEMPEST) - Manual (Page 39)

39 User Controls
IND100064-21
Display / Setup / Load Default / Save User Default
Function only available in “Full” menu mode.
This function will create and save a own custom User Default based on what settings and parameters
the user has edited in the OSD Menu. It will never save over the Factory Default, and it completely
independent. This can also be useful for customers who want to specifically preset the OSD Menu after a
certain company or usage/operation policy.
● Press the right (►) button to activate. A confirmation requester will appear. Use +/- to confirm.
Display / Setup / Direct Access (also known as hotkey)
This function will configure the hotkey functionality. It means that the user can access a function that is
normally only accessible by browsing through the OSD Menu and locate the function.
Available assigned hotkey functions are:
Brightness, PIP Size, Main Source, Second Source, Alpha Blend, Video Scaling, Swap Source*,
Test Pattern, No Function.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.
* NOTE: When assigning “Swap Source” to hot key function, it is advised to set the “Auto Source Select” to Enable (see page 40).
Display / Setup / Test Pattern
This function will show a typical test pattern with greyscales, colors and raster patterned boxes to check for
deviations in the TFT panel/display controller behaviour. It is independent of any current resolution or
specifications found in the signal inputs. The test pattern is generated internally in the display controller and
is sent 1:1 directly to the TFT panel. It can be therefore be used in trouble-shooting situations to determine
that the display are not or are the reason for a faulty or undesirable operation. The problem may be from
external equipment. Also, this function will be handy to check the display quality without having any
signal input available to test with.
● Press the right (►) button to activate the function, and hold “MENU” key for 3 seconds exit the test.
Display / Setup / Service Menu / Type and Serial
Function only available in “Full” menu mode.
This function will show the unit’s Type Number and Serial Number. This information is stored electronically
on a board chip component. Example: “JH 23T14 MMD-AA1-AAAA-000001”
Display / Setup / Service Menu / EVX Firmware Ver
Function only available in “Full” menu mode.
This function will show the firmware version (software OSD) of the display controller. This information is
stored electronically on the EVX component board.
Example: “E0.30.00 1”.
Display / Setup / Service Menu / ECOM Firmware Ver
Function only available in “Full” menu mode.
This will show the firmware version on the internal micro controller. This information is stored electronially
on a board chip component. Example: “SW100062-1E5”.
OSD Menu Functions