Heath Consultants Heath Data Recorder (HDR) - Manual (Page 16)

16
HDR Configuration- Detailed
User Friendly Names (Allows custom channel names of active channels- when required)
1. Go to the Configure Column/ “User Friendly Names”
2. Click the check-box next to the channel to add or type a custom name for the channel.
Note: This custom name will follow the channel throughout the software & reports.
Site info and Instrument Modem
1. Enter Site Address info. Note: Site address line #1 will be used to create filenames for downloaded reports.
2. Set baud rate to match the remote modem (if connected).
3. “Analog Modem” checkbox affects the time between dialing out to “Call out upon alarm”. Unchecked will cause the
three calls to be 2 mins apart (recommended for cellular modems to give the modem time to properly dial all three
calls). Checked will cause calls to go out ASAP (best used with land-line modems because they can dial all three calls
fast).
4. Set up Modbus here (Parity & Modbus mode: ASCII or RTU. RTU not active at this time).
Note: “The Schedule Reporting via E-mail”, “Alarm Notification via E-Mail” & “Access Telephone numbers” isn’t
active at this time (See below).
#2
#1
#3
#4
These three
features
aren’t active
at this time
Call out to pager/ phone
feature configuration.