Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 45781 Series - Manual (Page 25)

Chapter 3: Getting Started
Product Service 1-800-522-7658 21
14.
Press the ▼ button and the arrow on the display will point to DRY BLOWER.
15.
Press either the ► or ◄ button and the dry cycle blower will be energized.
16.
The ▼ arrow in the lower right side of the display indicates that more
selections may be made. Press the
▼ button to select the next function to test.
The arrow on the display will point to LIQ DETERG PUMP.
17.
Press the ► or ◄ button and if the liquid detergent accessory has been
installed and if it was activated in the Set Up procedure, the detergent pump
will operate.
18.
Press the ▼ button and the arrow on the display will point to LIGHT.
19.
Press either the ► or ◄ button and if the washer is equipped with a window
in the door, the light inside the washer will illuminate.
20.
Press the ▼ button and the arrow on the display will point to COOL FAN.
21.
Press either the ► or ◄ button and the small fan inside the kick panel will
operate.
22.
This completes the check of most of the washer functions. Unlatch the door
to exit from the Diagnostics mode.
23.
To verify the proper operation of the overfill switch, repeat steps 1 & 2 above.
Press either
► or ◄ button and allow tap water to enter the tank until the
water flow turns off.
24.
Press and hold the RUN button. Water will enter the washer and should turn
off before it overflows.
25.
Press the ▼ arrow until DRAIN/COOL is highlighted.
26.
Press ► or ◄ button to drain water from the washer.
27.
Unlatch the door to exit from the Diagnostics mode.