Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 45781 Series - Manual (Page 51)

Chapter 7: Troubleshooting
Product Service 1-800-522-7658 47
PROBLEM CAUSE CORRECTIVE ACTION
Washer will not
drain Clogged drain Clean out drain.
Blockage of air gap Clean the air gap by lifting the cover,
unscrewing the cap, and removing any
accumulated material. See Chapter 5.
Kink in drain hose Check for a kink in the drain hose.
Filter blocked Check filter in washer and clean as needed.
Drain valve or pump
not operating Check operation.
Washer will not
fill Fill valve clogged Clean fill valve.
Water supply turned
off Turn on water.
Defective fill switch Check operation.
Washer overfills Defective fill switch Check operation.
Selection buttons
on control panel
inoperable or
controls
malfunction Microprocessor
memory error Perform "Factory Reset." Open latch on door.
Press
▼ button and simultaneously close door
latch. Release
▼ button and display will show
the set up screen. Press
▼ until FACTORY
RESET is highlighted. Press
► or ◄ until “Yes”
is displayed. Press RUN.
Key pad defective Replace key pad.
Drain Fail Alarm Drain Valve
inoperable Listen for click when washer should drain.
Check for mechanical restriction of actuator arm
on top of valve.
Check for electrical power to valve.
Check for damage to valve coil.
Drain Pump
inoperable Check if pump fan turns when washer should
drain.
Check for mechanical restriction of fan.
Check for electrical power to pump.
Drain hose not routed
properly Hose from drain pump must slope upward and
have no low spots or horizontal runs under
washer tank.
Make sure hose is attached to the back of the
washer and has a high loop.