Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 45781 Series User Manual
Page 32
Chapter 4: Using Your Washer
Product Service 1-800-522-7658
28
28
Any of the standard factory wash programs may be customized to suit specific
wash requirements. All changes made to the programs will be stored in the
washer microprocessor’s memory until it is changed again. If a FACTORY
RESET is performed, all inputs entered by the user will be erased and the
programs shipped with the washer will be reinstated. It is possible to customize
the following program parameters:
Wash 2 temperature
Wash 2 time
Total number of rinses
Number of purified water rinses
Final rinse temperature
Enable or disable the steam function
Dry temperature
Dry time
In addition, when USER 2 program is selected, it is possible to set:
Wash 1 time
Rinse time (all rinses will be the same time)
To program and start a wash cycle:
1.
Close the washer door and slide the latch to the right. This energizes the
electronic control and the display will show the last program that was run.
2.
Press RUN to select this program.
3.
If a different program is desired, press DISPLAY. The available programs
will be shown on the display.